Hp insight management wbem providers for windows

Click Add and then OK to close the windows. If you try to install it gives a unsupported OS message. Why so late getting support for ? Specifically I want to use on a Hyper-V Is there really no way to get the HP system management homepag running under Windows Server ? I want to know about the status of my disks that are attached to a P smart array controller. You may install below HPE Smart Storage Administrator utility to see if detects storage controller to gather requested Drives health status.

Thank you SB6 That did it! Just installed it again and then found it unter Windows System in the start menu. Resources Announcements Email us Feedback. Log In. New Discussion. Thank you Solved! All forum topics Previous Topic Next Topic. HPE Pro. Hi, Thank you for posting your query in HPE community! Regards, pragav I work for HPE.

Thanks for your answer! I installed the SIM 7. The system management homepage stays empty. Is there anything else I need to do? I dont get this. You are invited to get involved by asking and answering questions! Intuitive to Use. Easy to manage. Find out how you can reduce cost, increase QoS and ease planning, as well. Update: For Gen10 servers, these sensors no longer require HP system management tools. Instead, the sensors need the Agentless Management Service installed on the target device.

However, we received this note from a customer:. After doing so, PRTG was able to configure sensors for just about everything except the Smart Array controller and its drives. I don't have the WBEM provider installed on any of my Windows servers, so, it appears this is a must for Windows , or at least with R2.

Up Down Hello,. Now all you have to do is make sure SNMP is set up properly and secure if required on the server you are wanting to monitor. The description in the MIB describes the different status codes - a "2" is normal, then you have other different integers. Add a Change Trigger Notification to notify you when the 2 changes to a different number and then you are done. When you get an error that the state changed, you know you need to run the Array Configuration Utility ACU and see exactly what happened.

Both report overall status, fan status and temp's but neither will show me RAID information. Drilling down shows status for the physical and logical drives. Up Down you do not get anything at all for the Logical or Physical disk sensors? Up Down Nope, nothing for disks.

Up Down hello,. Problem is that the responsible developer will not be available for another two weeks. Still, please send a mail to [email protected]. I can check the error count and the Error status Running does appear to be 2.

Up Down Thank you very much Simon. The oids you just mentioned can give an a quick overview over some of the parts of your systems. We will do some research and we will see if and how to include them into PRTG. If you define a lookup file, you will eben be able to get PRTG to show the textdescription instead of the raw value. Up Down Is this sensor supported for Windows R2? Add sensor failed with error "Could not find any disk on this device. HP System Management Homepage can see statuses from all physical disks.

I am using the same setup as on Windows Server R2 where it works. Please send us the resulting log from the Tester. Up Down Hello, I made two tests. Second test is on server where Phisycal Disk sensor works.